Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login

    M3D QUAD EXTRUDER ON DUET WIFI OR ETHERNET

    General Discussion
    3
    4
    543
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • dr.talyundefined
      dr.taly
      last edited by

      Hello, i have a question: is there the m3d quad extruder compatible with the duet wifi or duet ethernet boards? i was thinking to buy it for make more videos on my youtbe channel but i only see it on duet maestro board. anyone can help me? best regards

      Martin1454undefined 1 Reply Last reply Reply Quote 0
      • Martin1454undefined
        Martin1454 @dr.taly
        last edited by Martin1454

        @dr-taly Yes it is, - They run the (almost) same firmware

        1 Reply Last reply Reply Quote 0
        • dc42undefined
          dc42 administrators
          last edited by

          Yes it's compatible; but you will need 7 stepper drivers in total (3 axes + 4 extruders), so to drive the quad hot end you need either a Duet WiFi/Ethernet + DueX2 or Duex5, or Duet Maestro + 2-stepper daughter board.

          Duet WiFi hardware designer and firmware engineer
          Please do not ask me for Duet support via PM or email, use the forum
          http://www.escher3d.com, https://miscsolutions.wordpress.com

          1 Reply Last reply Reply Quote 0
          • dr.talyundefined
            dr.taly
            last edited by

            Thank you for the clearence. I will upload soon.

            1 Reply Last reply Reply Quote 0
            • First post
              Last post
            Unless otherwise noted, all forum content is licensed under CC-BY-SA