X, Y and Z stop connections with Reed sensor
-
Hello! I've reached to X, Y, and Z Stop connections for Duet Fifi controller. Each connection has 3 contacts (pins), but for my BFB 3D Touch printer are Reed (magnetic) sensors with two wires.
Do I think right if I want to connect one wire to a Stop pin and the other to a +3.3 V pin? Then the ground pin will be free. Is will be correct? -
-
@army61 One wire to the ground pin and the other to the signal pin. The 3.3v pin is not used.
-
@stephen6309 said in X, Y and Z stop connections with Reed sensor:
@army61 One wire to the ground pin and the other to the signal pin. The 3.3v pin is not used.
That's correct. Use the two outer pins of each endstop connector.
-
@stephen6309 Thank You so much!
