Print FAN0 problem, works as always on?
-
Hi. FAN0, FAN1 and FAN2 have pins VFAN and FAN- . If yours is connected to GND, are you sure it isnt "always on" fan connector?
-
@aidar Yes, I am sure that air pump is connected to FAN0- (GND) and other wire(red) to 24V IN. And I can control it through web interface, but when I change the speed to 0% - it is actually seems like 50% at the air pump.
-
Hmm...and i bet you dont have L parameter in M106 command. I would try to change PWM frequency, F parameter, as suggested in https://duet3d.dozuki.com/Wiki/Gcode#Section_M106_Fan_On.
Also, thermostatically controlled fans min speed is 0.5, so make sure you didnt config it as thermostatically controlled. -
@aidar This is my setup: M106 P0 S0 I0 F100 H-1 (tried different F up to 25000)
-
@dc42 help please. Do I need a flyback diode? (I thought 1.04 board don't need them). Do I need current restrictive thermistor? (But fan is running without problems)
-
Type M106 P0 and post the output.
-
@sigxcpu said in Print FAN0 problem, works as always on?:
M106 P0
Here is the output: Fan 0 pin: F0, frequency: 100Hz, speed: 0%, min: 10%, max: 100%, blip: 0.10, inverted: no
As I understand you have found my error? min: 10% ? How do I set it to 0% and where it was set as I don't have limits in my config.g
-
Set it to 0 with L parameter : Fan 0 pin: F0, frequency: 100Hz, speed: 0%, min: 0%, max: 100%, blip: 0.10, inverted: no
Still spinning and fast enough...
-
Info about fan: 24V , 0.15A, brushless motor
-
Ok, have found a problem. I have 5V FAN1, FAN2 and always-on fan + 24V brushless air pump. So I need to change V_FAN to 24V and use a convertor for my 5V fans or find source of 5V because(as I assume) of flyback diode.
-
@briskspirit said in Print FAN0 problem, works as always on?:
Ok, have found a problem. I have 5V FAN1, FAN2 and always-on fan + 24V brushless air pump. So I need to change V_FAN to 24V and use a convertor for my 5V fans or find source of 5V because(as I assume) of flyback diode.
That's right. When using controlled fans/pumps that take different voltages, V_FAN must be the highest one, otherwise the flyback diodes will conduct.
