Filament monitor reported to much movment
-
I have a magnetic filament monitor which run smoothly form almost a yeat and many prints, but lately I am receiving this error How can I get rid of it. The print run smoothly and everything seems ok so even after resuming the print.
-
Iam trying to investigate the cause of this error.
I did a M591 D0 R-1
but my value are a lot worse then before .
now I have
Duet3D rotating magnet filament monitor on endstop input 3, enabled, sensitivity 28.80mm/rev, allowed movement 0% to 160%, check every 3.0mm, current position 255.2, measured sensitivity 23.05mm/rev, measured minimum 114%, maximum 135% over 39.4mmlast time a did a check tolerance +12% -9%
Can someone explain me this value?
thx
Andrea -
Could it be that the magnet on the rotating shaft is no longer aligned with the centre of the sensor chip?
-
Thank you for answering me .
I cleaned and checked the sensor and it seems fine.
The starnge things , for me is that minimum and maximum are over 100% but the variation is still low
measured minimum 119%, maximum 136% so 17%.
I can't undestand why before I had always a variation of about 30% but -10% +20%
