Independent Z Motors, leveling until acceptable deviation?
-
I am trying to speed up my print start times, and just make things a little more efficient. Such as not heating the hotend until it's closer to time to print, rather than 10 minutes before while it does it's probing, leveling, etc.
My questions is, is there a way to setup the independent Z leveling so that it continues to probe the points in my bed.g file until the deviation is lower than a set amount?
I'd like to set it to probe until deviation is less than or equal to 0.01, as I frequently print at 0.05mm layer heights.
Basically I want similar to the Z probe setting, where it continues to probe until it's close but on the multiple Z motors bed leveling.
-
It's not supported yet,but it's in the firmware wish list.
-
@dc42 said in Independent Z Motors, leveling until acceptable deviation?:
It's not supported yet,but it's in the firmware wish list.
Awesome. Thanks for the quick response.