Cant get my nozzle close to bed at all when trying to print

[Puppet172]

@dc42
Where is that located?

[Puppet172]

@T3P3Tony
I have motors and ends stops and a hotend and just some regular 3d printing stuff but thats the only stuff plugged into the board.

[T3P3Tony]

@puppet172 said in Cant get my nozzle close to bed at all when trying to print:

@dc42
Where is that located?

Its this one:

@puppet172 said in Cant get my nozzle close to bed at all when trying to print:

I have motors and ends stops and a hotend and just some regular 3d printing stuff but thats the only stuff plugged into the board.

Can you try with nothing plugged in other than USB.

[Puppet172]

@t3p3tony
Yes just give me a couple min to unplug everything and im going to check if it gets hot one everything is unplugged

[Puppet172]

@T3P3Tony @dc42
When nothing is plugged into the board but the USB it does not get hot but when the 12v is applied it does get hot

[dc42]

If you comment out the M552 command in config.g so that the WiFi module stays disabled, does everything remain cool and does YAT remain connected? If so then perhaps just the WiFi module is faulty.

[Puppet172]

@dc42
the wifi module gets warm even when commented out but it still disconnects it seems when ever i send a command and then after a while of sittin there it will time out on its own and just disconnect

[T3P3Tony]

@puppet172 thanks for the report. can you monitor the MCU temperature (repeated M122 calls over YAT). with just USB plugged in.

[Puppet172]

@t3p3tony @dc42

Not Reliably because i get get the command output to pop up every once in a while but its kinda dependant on luck and perfect timing it seems because as i send the command it kinda disconnects then recconects
@T3P3Tony

[Puppet172]

@dc42 @T3P3Tony

Hi, so as it looks now the board still does the same thing and i have been able to get and different outcomes
So am i gonna need to get new boards?
Since i bought it on the 21 of February this year would it be covered under warranty?
Thanks

[T3P3Tony]

@puppet172 yes, please contact who you bought the board from and reference this thread.