Heatbed Tuning
-
I am attempting to get my heated bed to tune for printing ABS. It's a stock Maker Select V.2. With a Rambo Mini, I was able to get it to 110* C easily. I can get it tuned to 90*, albeit hit and miss. About half of the time it will fail. If trying to go above, I get a bad curve error. I have swapped between a Meanwell 12v 500w supply, the stock supply, and a Corsair AX750 and Antec Earth Power 600 watt atx supplies, so I don't think it's a power issue or a bed issue. Here's my error:
3:13:48 PM
Warning: Auto tune of heater 0 failed due to bad curve fit (G=67.4, tc=239.3, td=-1.2)
3:10:08 PM
Auto tune phase 3, peak temperature was 100.0
3:10:01 PM
Auto tune phase 2, heater off
2:59:21 PM
Auto tune phase 1, heater on
2:59:15 PM
M303 H0 P1.0 S100
Auto tuning heater 0 using target temperature 100.0°C and PWM 1.00 - do not leave printer unattendedAny suggestions?
-
The problem is that when the heater has barely enough power to reach the desired temperature, the measurement of dead time during heater tuning becomes difficult. I suggest you tune it at about 85C. The same heater model should work at higher temperatures too.
-
Worked like a charm, thanks. Also turning off the fans during warmup helped a lot. >.> Forgot to disable them during heating.
