Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you have been placed in read-only mode.

Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).

pid tuning never ends

Unsolved

General Discussion

3

6

91

Log in to reply

undefined

gnydick
last edited by

I'm using 6hc + tool distro board + 1Lc with M303 T0 S320 and it never finishes. The graph is extremely smooth and consistent. It just never ends after getting to the fourth phase.
undefined 2 Replies Last reply
Reply Quote 0
undefined

T3P3Tony administrators @gnydick
last edited by

@gnydick which firmware version is this?
www.duet3d.com
undefined 1 Reply Last reply
Reply Quote 0
undefined

Phaedrux Moderator
last edited by

How long is never?
Z-Bot CoreXY Build | Thingiverse Profile
undefined 1 Reply Last reply
Reply Quote 0
undefined

gnydick @T3P3Tony
last edited by

@T3P3Tony 3.5.3
1 Reply Last reply
Reply Quote 0
undefined

gnydick @Phaedrux
last edited by gnydick

@Phaedrux over an hour after it hits phase 4 and has settled
1 Reply Last reply
Reply Quote 0
undefined Phaedrux marked this topic as a question
undefined

T3P3Tony administrators @gnydick
last edited by

@gnydick does it tune successfully at a lower temp (e.g. 220?)
www.duet3d.com
1 Reply Last reply
Reply Quote 0

1 / 1