Help with configuration

[Pranayme]

@fcwilt Well the warning is gone, but the error still remains

[fcwilt]

@Pranayme said in Help with configuration:

@fcwilt Well the warning is gone, but the error still remains

So you removed the T parameter?

Frederick

[Pranayme]

@fcwilt Yes, but got the same error

[fcwilt]

@Pranayme said in Help with configuration:

@fcwilt Yes, but got the same error

You are "re-booting" after changing config.g - correct?

Frederick

[Pranayme]

@fcwilt No i didn't reboot. I sent M98 P"config.g"

[fcwilt]

@Pranayme said in Help with configuration:

@fcwilt No i didn't reboot. I sent M98 P"config.g"

Just to be safe try a re-boot. I vaguely recall that some configuration settings need a re-boot to clear them.

I always re-boot to be safe.

Frederick

[Pranayme]

@fcwilt
Tried reboot, but same thing.
Error: Setting not available for external drivers

[fcwilt]

@Pranayme said in Help with configuration:

@fcwilt
Tried reboot, but same thing.
Error: Setting not available for external drivers

OK thanks.

Let me take another look.

[fcwilt]

@Pranayme

While I ponder this you could try a "brute force" approach and edit things so you are:

• configuring X only
• test
• then add Y
• test
• then add Z
• test

Tedious but likely to reveal the problem.

Frederick

[fcwilt]

@fcwilt

Oh, you have a M569.7 command twice.

It may or may not matter.

Frederick

[Pranayme]

@fcwilt I did this, X,Y and Z axis were fine. The error came when I had the extruder configuration alone.

[fcwilt]

@Pranayme said in Help with configuration:

@fcwilt I did this, X,Y and Z axis were fine. The error came when I had the extruder configuration alone.

Good job.

Now we can focus on axis E.

How about adding back each E related item and test.

One of them should be the source of the error.

Again tedious but likely effective.

Frederick

[Pranayme]

@fcwilt Error was with the M906 command

[fcwilt]

@Pranayme said in Help with configuration:

@fcwilt Error was with the M906 command

Good job.

I know it was tedious but it worked.

I wonder how you do set the current for that stepper - clearly related to using the 1XD board.

Frederick