@fcwilt Error was with the M906 command

@fcwilt I did this, X,Y and Z axis were fine. The error came when I had the extruder configuration alone.

@fcwilt
Tried reboot, but same thing.
Error: Setting not available for external drivers

@fcwilt No i didn't reboot. I sent M98 P"config.g"

@fcwilt Yes, but got the same error

@fcwilt Well the warning is gone, but the error still remains

I get this error when i try M98 P"config.g"

Error: Setting not available for external drivers
Warning: Macro file config-override.g not found
This is my configuration file.
config (1).g

I have one motor on each of x,y and z axes. and one extruder motor. Extruder is connected on to 1XD board and Z is connected to HCL board. The main board is 6HC v1.02. Firmware is 3.4.5.

Can anyone help me please. Thanks in advance.

My extruder is connected to the 1XD(Can address: 121) board as shown in the picture. How do i configure it.
M569 P121.0 S1 ; physical drive 121.0 goes forwards
M584 X0.0 Y0.1 Z122.0 E121.0 ; set drive mapping
M350 X16 Y16 Z16 E16 I1 ; configure microstepping with interpolation
M92 X20.00 Y20.00 Z40.00 E100.00 ; set steps per mm
M566 X900.00 Y900.00 Z60.00 E120.00 ; set maximum instantaneous speed changes (mm/min)
M203 X6000.00 Y6000.00 Z180.00 E1200.00 ; set maximum speeds (mm/min)
M201 X500.00 Y500.00 Z20.00 E250.00 ; set accelerations (mm/s^2)
M906 X3360 Y3360 Z3360 E2987 I30 ; set motor currents (mA) and motor idle factor in per cent
M84 S30
Is my configuration correct.

@nikscha said in Need help with setting up configuration:

noticed that your comment says board 40, yeah that was copy error.
yeah, I'm using external supply for the motor break. yeah i got the jumpers correctly.

@nikscha Is my configuration correct, especially the brake configuration for the z- axis on board 122