[3.5.0-b2] DWC Strange Slider Behavior

CCS86

Adding one more thing:

When my part cooling fan is set from 1% - 49%, the "tool fan" shows 0%. Set from 50 - 100% the "tool fan" shows 1%.

Fans.mp4

When manipulating the "tool fan" slider, the behavior is even more strange:

Fans2.mp4

CCS86

Hello? Should I have posted this on Github?

T3P3Tony

@CCS86 thanks for the report, here is the right place for it.

@chrishamm I have reproduced the issue with DWC in SBC mode 3.5b2 . It appears that the "Tool Fan" is being set between 0 and 1 rather than between 0 and 100.

chrishamm

@CCS86 Thanks, I could confirm that the tool fan didn't work correctly, that will be fixed in 3.5-b3.

The speed factor slider works as intended, it updates the min/max values whenever the speed factor value changes.

T3P3Tony

@chrishamm yes, the speed slider was (AFAIK) being moved in the video to show an example of how a slider should work!

chrishamm

@T3P3Tony Speed/extrusion are somewhat special because there's no hard limit of 0..100 for them.

T3P3Tony

@chrishamm sure, i was just pointing out that there was no bug alleged with the speed slider.

CCS86

Awesome, thanks guys!

CCS86

Any progress on this @chrishamm ?

chrishamm

@CCS86 It's been fixed since 3.5-b3, see the DWC changelog on GitHub:

- Fixed tool fan on the Job Status page