3HC and Input shaping

[tmitch205]

Hello folks,

I am wiring up a new printer with a 6HC, a 3HC, and a 1LC.
There will be 4 Z drives, 1 X drive, and 2 Y drives.
If the drives for X and Y are on the 3HC, will input shaping work, or is that still not supported on the expansion board?

Thanks,
T

[dc42]

@tmitch205 input shaping is not yet supported on axes driven by CAN-connected expansion boards. It was scheduled to be implemented in RRF 3.5 but as 3.5 is already very late it may be delayed until 3.6.

[tmitch205]

@dc42 Thank you for the confirmation. This prevents me from having to redo the wiring and firmware moving forward on a hope, lol.