M675 not stopping when reaching X max

Menthos

Hi, hopefully somebody knows what I’m doing wrong. I’m using the following to probe the cavity of an openbuilds XYZ probe:

M675 X R8 F100 P0 ; Find center in X axis
M675 Y R8 F100 P0 ; Find center in Y axis

…and it moves and senses the X min, stops and then moves to sense the X max, but doesn’t stop. I’m hitting the estop.

I can see the XYZ probe registering the contact (green light)

Fingers crossed it’s something seen before.

Menthos

Sorted that bit - the 'R' setting was way too high... set it to 2 and that part works.

dc42

@menthos I think the R value only needs to be high enough to guarantee that the probe stops registering contact after moving away from the minimum.

Menthos

@dc42 Ah, ok, that would make sense... I'd read that as being the amount of travel it did to 'find' the edge.

Thanks!!

dc42