More fried PWM fan MOSFETs (probably)
-
Yes, I apparently fried mine as well. I do get some voltage through, but only 7.75 on those that function and 0 on the others.
-
Maybe you can find someone who has hot air equipment and can replace the MOSFETs for you. Is there a makerspace or hackspace near you? Which country are you in?
I'm in the UK but unfortunately don't know anyone into electronics. There is a FabLab here but they weren't keen on allowing the public in when I contacted them a while ago.
-
If you PM me later this week I may be able to help.
-
Thank you, I will do that.
-
What Mosfet is a proper replacement? I can read the WK8 but not what is after it. is it uncommon for this to happen, I have around 200 hr on the board, thats it.
-
https://duet3d.com/wiki/Connector_and_spare_part_numbers
The fan mosfet will blow if you short the corresponding output. Depending on the fan, it might also blow if you connect the fan wires the wrong way round.
-
Found this with some help from Google, but no idea if its right, Google can be like WebMD you go in with a paper cut …next thing you know you're going to die.
https://www.digikey.com/product-detail/en/nexperia-usa-inc/PMV40UN2R/1727-1900-1-ND/5056345
-
didn't see your response before I posted, thanks
-
I also blew a couple of the fan mosfets, my fault , and was able to replace them without using a hot air station. I used a small pointy soldering tip and liquid flux and some small copper braid and no coffee before doing it. If you don't have much soldering experience I would suggest watching a few youtube videos on SMT removal without a hot air station and practicing on some junk electronics first.
-
If you PM me later this week I may be able to help.
I sent a message (I think), hope you got it.
