Duet 3 MB6HC V1.01 I2C Connection
-
Is it possible to use the i2c protocol to communicate with the MB6HC Board?
(M260/261)
Which Connector to use? IO2 is documented with
„I2c possible with added Resistors“
But no further informationI want to connect a EEPROM to it.
-
@neueklasse in theory the MB6HC could support I2C on IO2 if the input protection resistor was bypassed. On the next MB6HC revision we will probably add a jumper to make it easy to bypass this resistor.
However, the MB6HC build of the firmware doesn't currently support I2C.
-
@dc42 Is it possible to get a Schematic and Circuit drawings from the Board itself?
-
@neueklasse the Schematic is here:
https://github.com/Duet3D/Duet3-Mainboard-6HC/tree/master/Duet3_Mainboard_v1.01I will move this to the firmware wishlist.
-
@t3p3tony thanks!