duet wifi 2 without internet
-
I am currently living in an apartment without internet through a wifi router. I was wondering if i can still use my duet wifi 2 board with a panel due screen. I turn on the printer but the screen says connecting on it and wont give me full range options of the printer. Is there something i need to add to the config?
-
@drak yes you can. RepRapFirmware does not require an Internet connection. You can also configure RRF to run in access point mode and use a PC, laptop or smartphone to control it, instead of (or as well as) a PanelDue.
If PanelDue is stuck on Connecting then most likely you haven't configured RRF for the PanelDue, or you haven't configured the same baud rate at both ends, or there is a problem with the cable.
Duet WiFi hardware designer and firmware engineer
Please do not ask me for Duet support via PM or email, use the forum
http://www.escher3d.com, https://miscsolutions.wordpress.com -
@dc42
thank you for the response,how do i make sure the reprap firmware is configured for the paneldue.
In my config i included this command for the panel due
M575 P1 B57600 S1Also how do i configure the RRF to run in access point mode?
