Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you have been placed in read-only mode.

Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).

Water pump operation during extrusion

Using Duet Controllers

2

4

154

Log in to reply

undefined

MRJEON
last edited by

When extrusion occurs, the air sol valve and water pump are operated. Is it possible using relay 5v module on duet2 board?
1 Reply Last reply
Reply Quote 0
undefined

Phaedrux Moderator
last edited by

Maybe this? https://duet3d.dozuki.com/Wiki/Gcode?revisionid=HEAD#Section_M571_Set_output_on_extrude
Z-Bot CoreXY Build | Thingiverse Profile
undefined 1 Reply Last reply
Reply Quote 0
undefined

MRJEON @Phaedrux
last edited by

@phaedrux Thank you. But I have a question. Where is pin3 on the duet 2 board? Is it pwm in the wiring map?
1 Reply Last reply
Reply Quote 0
undefined

Phaedrux Moderator
last edited by

Pin 3 is an example for RRF2, surely you must be using RRF3 by now and can use the pin name itself you wish to use?
Z-Bot CoreXY Build | Thingiverse Profile
1 Reply Last reply
Reply Quote 0

1 / 1