I homing and tried to make x and y work. But all of them only move in the + direction and not in the - direction. For what reason?
Latest posts made by MRJEON
-
Does the polar printer not move in the - direction?
-
Is there a way not to use zprobe?
My printer doesn't have a z-axis limit sensor.
So I want to match the nozzle and bed manually and let you know the zero point. Is it possible? -
What is the maximum command pulse train for duet 2?
What is the maximum command pulse train for duet 2?
-
RE: Water pump operation during extrusion
@phaedrux Thank you. But I have a question. Where is pin3 on the duet 2 board? Is it pwm in the wiring map?
-
Water pump operation during extrusion
When extrusion occurs, the air sol valve and water pump are operated. Is it possible using relay 5v module on duet2 board?
-
RE: AC servo motor with Duet2 Ethernet + Expansion Board
@dc42 I will set the timing from 1us to 4us and respond after driving. Thank you for letting us know!
-
AC servo motor with Duet2 Ethernet + Expansion Board
I finished wiring to operate the AC servo motor with Duet2 Ethernet + Expansion Board. For commissioning, the movement from 0 to 100 is confirmed on the DWC interface, but the actual motor does not move. What is the problem?
-
RE: duet 2 ethernet connection not available
m552 s0
Network stopped
ok
m552 s1
ok
Network running, IP address = 192.168.1.34
m552 s1 p0.0.0.0
ok
m552 s1 p192.168.1.34
okbut... I can't connect DWC...
-
duet 2 ethernet connection not available
m552 s1 p192.168.1.34
ok
Network running, IP address = 192.168.1.34
m552
Network is enabled, configured IP address: 192.168.1.34, actual IP address: 192.168.1.34
ok
m553
Net mask: 255.255.255.0
ok
m554
Gateway: 192.168.1.255
okbut...Cannot connect to 192.168.1.34
in tcp/ipv4 setting
I matched the subnet mask and gateway, but I can't connect to dwc..what's wrong..?
-
RE: Axis limits
Then, if the minimum value x 0 and the maximum value x 150, is the zero point x 75?