axis +- setup
-
Hello,
I found a help with this.
How to change the direction in the firmware please ?
The zero is the end stop, If I need move for example +10 for x this is from the endstop that's right?
Thanks
-
-
I change S1 to S0 but now I have only one on 3 Z motors moving
-
@auré Add line in config cfg with the number of driver M569 P0.3 S0
-
I can't tell... did you get it solved?
-
@phaedrux Hello, yes. at the beginning I have just the line M569 P0.3 S1, I change S1 to S0 I have only one nema that work.
I add:M569 P0.3 S0
M569 P0.4 S0
M569 P0.5 S0Before M584
And there is ok