Error: Short-to-ground on drivers 0 Error: Over temperature shutdown
-
I blew the x driver on my board. I remapped my axes and removed the old driver with a soldering iron. Everything worked fine until I updated to the new firmware and now I get spammed with
Error: Short-to-ground on drivers 0
Error: Over temperature shutdown on drivers 0It still heats up and moves but that is kinda bothersome. Can I disable this?
-
Only by installing a new driver chip. It's possible that connecting a small signal Schottky diode between the CS and SDO pads for that chip (cathode to CS) might also work, but I haven't tested it.