Running Low Current Motors on Duet 3 6HC
-
Hello,
I am awaiting my Duet 3 6HC board I ordered a few days ago.
Is there any issue running all my Nema 17 motors, at their respective specs (under 1.5-2A each generally) ?
I was reading some documentation that made me feel like it was suggested to run motors at a certain current
-
I don't think there is an issue with running lower current motors on the 6HC. The recommendation is to set the current to 60-85% of the rated max of the motors. If anything it's a bit of a waste to have such powerful drivers and use smaller motors, but that just means they will be running cool.
-
I forgot to add:
I had ordered some wiring connectors to crimp along with a PA-09 (had a PA-21 already for jst-xh 2.54) , do I just need the Molex KK and JST-VH 3.96 ?
-
There should be a crimp connector pack included with the board.
-
@phaedrux Yes I received that I am of the variety that likes to have extra and be prepared and it seems the JST-XH/PH 2.54 are not a match to the ones that came with the board.
I am trying to determine what the correct types are to orderthanks again all
-
