Need help diagnosing bad stepper output signal on Duet 3
-
@Noah said in Need help diagnosing bad stepper output signal on Duet 3:
M350 X16 Y16 Z16 E16:16:16 I1 to M350 X16 Y16 Z16:16:16 E16 I1
The Z axis only needs a single entry as well. It's only when you have multiple extruder axis that each axis needs to be defined. The other axis with multiple motors all use the same settings since they aren't independent.
So remove the multiple Z values as well.
-
@Rushmere3D JYNX again!
-
@Phaedrux haha
-
ok, haha
thank you so much for dealing with the noob over here. I corrected all of the lines after m671 to show only one value for X,Y,Z,E
I was just copying what the RRF config tool gave me for the multiple E motors since it did not have any option to add extra Z motors.
Z homing and G32 working perfect again, and I only have one data point for motor 5 now
Fingers crossed. -
as soon as the hotend heats up and it will let me send extrude and retract commands, I'll let you know if the ext motor is behaving any differently now
-
Hahahaha Phaedrux & Rushmere You guy are amazing!!!
wish I had asked a little sooner for someone to review my code... I really caused myself a couple of days of grief over here... I have good motor function on all motors now.
Now, I am off to tune my extrusion steps and try a print!|Thank You both soooooo much
Noah
-
Proper config for others refernce
; Drives
M569 P0.0 S1 ; physical drive 0.0 goes forwards
M569 P0.1 S1 ; physical drive 0.1 goes forwards
M569 P0.2 S1 ; physical drive 0.2 goes forwards
M569 P0.3 S1 ; physical drive 0.3 goes forwards
M569 P0.4 S1 ; physical drive 0.4 goes forwards
M569 P0.5 S1 ; physical drive 0.5 goes forwards
M584 X0.0 Y0.1 Z0.2:0.3:0.4 E0.5
M671 X-30.109:146.1:322.309 Y-10.413:317.797:-10.413 S50
M350 X16 Y16 Z16 E16 I1
M92 X160.00 Y160.00 Z1600.00 E873.00
M566 X1200.00 Y1200.00 Z30.00 E1800.00
M203 X18000.00 Y18000.00 Z1800.00 E3000.00
M201 X1600.00 Y1600.00 Z100.00 E2000.00
M906 X1200 Y1200 Z800 E950 I30
M84 S30 -
Glad you got it sorted.
-
I still do have the
Error: in file macro line 21: M350: array too long, max length = 1but only for the M350 line
That's strange... what doesn't it like about my M350 X16 Y16 Z16 E16 I1
-
Please upload your actual config.g file
