Second Layer Off & Offsets Question
-
thanks... hows that work? do i upload the file then put it in like this: "<download link>" or do i copy past the text in "<text>"?
-
@warbunnies said in Second Layer Off & Offsets Question:
thanks... hows that work? do i upload the file then put it in like this: "<download link>" or do i copy past the text in "<text>"?
You use the </> tag and paste your code between the two sets of ``` characters.
Frederick
-
@fcwilt said in Second Layer Off & Offsets Question:
M308 S0 P"temp0" Y"thermistor" T100000 B4138 ; configure sensor 0 as thermistor on pin temp0
all your thermistor settings are incorrect. find the correct beta value in your thermistor documentation
also what firmware verion are you running? there were some bugfixes regarding offset of tools in the last update.
-
@Veti I'll look into the thermistors... they are performing great though and not really an issue... if i was printing anything but pla on this machine for work it'd probably be more critical.
the firmware is: RepRapFirmware for Duet 3 MB6HC 3.01-RC9 (2020-04-21b1)
-
@warbunnies said in Second Layer Off & Offsets Question:
the firmware is: RepRapFirmware for Duet 3 MB6HC 3.01-RC9 (2020-04-21b1)
please update to 3.2
https://duet3d.dozuki.com/Wiki/Installing_and_Updating_Firmware -
@Veti Will do.... as soon as i figure out how. I've never actually used a pi before and I don't really understand how to send the "sudo apt update
sudo apt upgrade" commands. is there a way to initiate that from the duet ui or do i have to find a way to plug in the pi to a screen and keyboard? -
-
but if you are not familiar with linux, why are you running the duet in sbc mode and not standalone mode?
-
@Veti honestly cause that seemed like it was the suggested way of doing it... the instructions as i understood them made standalone sound like a dated alternative.
-
its not dated at all and works quite well.
some say it runs better in standalone. -
@Veti okay the ssh instructions seem clear enough. i should be fine pulling that off.
