Panel Due Move Head FeedRate changes.

sozkan

Hi,
I have Panel Due 5i. Could please guide how to reduce feed rate and acceleration values in the LCD device? Because of DWC Acceleration and speed setup not valid in the LCD.

Kind Regards

wilriker

@sozkan Acceleration is solely controlled by the corresponding M201 command in your configuration. Feed rate is indeed hard coded in PanelDueFirmware (at 6000mm/min) and cannot be changed by the user as of now. I will add an option to select from a couple of values in the next version.

sozkan

@wilriker said in Panel Due Move Head FeedRate changes.:

@sozkan Acceleration is solely controlled by the corresponding M201 command in your configuration. Feed rate is indeed hard coded in PanelDueFirmware (at 6000mm/min) and cannot be changed by the user as of now. I will add an option to select from a couple of values in the next version.

Hi,
Thanks for your answer. When do you estimate the changes?
By the way, not mandatory but, I believe the console interface also needs a scroll bar or simply page down and page up button also helps for the long diagnostics commands return.

wilriker

@sozkan I might include this in version 3.2.1 together with configurable baby-stepping amount and some fixes but I cannot promise this nor can I tell you about a release date.

Regarding scrollback buffer: right now and due to memory limits only the information on the screen in the console is saved. Everything that "scrolls out" is lost. I understand the issue when trying to review very long responses like those for M122 but that's just not what the PanelDue is intended for. But nevertheless I will think about it.

sozkan

@wilriker Thank you very much.

A Former User

@wilriker said in Panel Due Move Head FeedRate changes.:

I understand the issue when trying to review very long responses like those for M122 but that's just not what the PanelDue is intended for. But nevertheless I will think about it.

maybe simpler to use more targeted diagnostic commands, or add some new commands if M122 is the only source now?

dc42

@sozkan said in Panel Due Move Head FeedRate changes.:

Hi,
I have Panel Due 5i. Could please guide how to reduce feed rate and acceleration values in the LCD device? Because of DWC Acceleration and speed setup not valid in the LCD.

Why do you want to do this? Whatever speeds PanelDue requests, the M201 and M203 settings you specified in config.g will be honoured. If movements are too fast for your printer, you should reduce those settings.

sozkan

@dc42 said in Panel Due Move Head FeedRate changes.:

M201

Thank you very much. It is perfectly tuned.