extruder fault problem and upgrade to 24v.
-
@Dave-Parry said in extruder fault problem and upgrade to 24v.:
15A at 24v
it really depends on the power draw of your bed. can you tell us the rating?
also consider buying a high quality power supply from e.g meanwell
-
Cant find any info on heater bed power, but measuring resistance when cold gives 1.9 ohm which at 12v gives 6.3 amps which doesnt sound right. Neither of my multimeters go above 10a so their no use. Looking at similar square beds they seem to be about 200w. which would be about 15A
-
@Dave-Parry
can you link the heater? -
-
@Dave-Parry said in extruder fault problem and upgrade to 24v.:
Looking at similar square beds they seem to be about 200w.
yeah that sound like a good guesstimate
-
so say bed = 9 A,
v6 40w = 1.6A
nema 17 Stepper motors = 1.6A x 4, 6.4A
Thats about 17A, so I think I need 20A. does that sound about right?
I know the motors wont draw that much in realitity, but I think 24v 15 A is a bit low. -
see
https://duet3d.dozuki.com/Wiki/Choosing_the_power_supplyyou need to calculate the nema differently
-
So does that mean 2.8v x 1.68A = 4.5A per motor?
-
My Bad, just read again and its 1,68A + 50%= 2.5A x 4 = 10A
So thats 20 A + other bits.
So probably 25A or 30A is going to be the required current.
Thats a lot, no wonder 12v 15A is having problems. -
Definitely consider a meanwell supply from a reputable supplier like digikey or mouser.
-
Next problem is a power connector. 25 amps is a lot for a connector to handle.
My present one is a 8 way one, 3 for +, 3 for -, and 2 I think are for power switch.
Not sure what type they are but I think they are molex ones. What type do other machines use? -
@Dave-Parry said in extruder fault problem and upgrade to 24v.:
Next problem is a power connector. 25 amps is a lot for a connector to handle.
My present one is a 8 way oneI'm not sure what you're referring to? Photo?