Help needed - print quality issue
-
can you try to adjust to bondtech tension to a lot higher and try that?
-
@Veti said in Help needed - print quality issue:
can you try to adjust to bondtech tension to a lot higher and try that?
No difference. Still the corner where the layer starts
-
you did not yet say if the print with another slicer was better
-
@Veti said in Help needed - print quality issue:
you did not yet say if the print with another slicer was better
Oh sorry....no it's the same result.
-
and did you print one without pressure advance?
-
Yes, but in the meantine I changed some settings. Will do another print without PA.
I fear the worst that it is a mechanical issue. When I compare the prints the "bad corner" has the same pattern:
-
Without pressure advance it looks better but I still have the scars where the layer starts. I don't have an idea at all what to do next. Any more ideas from you experienced guys are very appreciated!
-
@MartinNYHC said in Help needed - print quality issue:
And another pressurte advance test...
What PA value did you land on?
-
when you grab the hotend with your fingers while the motors are powered, can you displace the hotend slightly?
-
@Phaedrux said in Help needed - print quality issue:
What PA value did you land on?
For now I'bve choosen 0.06. Not sure if that is the best choice.
-
@Veti said in Help needed - print quality issue:
when you grab the hotend with your fingers while the motors are powered, can you displace the hotend slightly?
Nope, it's tight.
