configuration change

[printingmark]

Hallo everybody
i had to remove my bltouch (defect)
changed the configuration and now the printer homes and try to print about 10 cm above the bed
can sombody please tel me what i am doing wrong
config.g
endstop works

[littlehobbyshop]

Config looks ok to me. Can you share your homeall.g, homez.g, and one of the gcode files that prints in mid air.
Does the same thing happen if you home each axis independently rather than all together?

[printingmark]

homeall.g homez.g

if I move the axis they go in the right direction
when i do home all the z axis goes up instead of to the end stop i have seen

sorry for my
English

[littlehobbyshop]

Ah OK. Have a look at M574

Currently you have no Z endstop set in your config.g with M574 Z0 S0.

I suspect you would instead need M574 Z1, you will need to set the S parameter depending on your endstop type.

[printingmark]

@littlehobbyshop that did the trick thank you very much