for the moment all is working, thank you verry much all for the help

@droftarts you where on the right track,one of the endstops was broken i saw movement in it while checking te connection
thank you

@littlehobbyshop that did the trick thank you very much

homeall.g homez.g

if I move the axis they go in the right direction
when i do home all the z axis goes up instead of to the end stop i have seen

sorry for my
English

Hallo everybody
i had to remove my bltouch (defect)
changed the configuration and now the printer homes and try to print about 10 cm above the bed
can sombody please tel me what i am doing wrong
config.g
endstop works

@Phaedrux thank you

@baird1fa thank you

Hallo everybody, hope you are doing well
i have some problems with my BLtouch, due to conect problems i had to put a backup back on the board, now if i try to probe the bed the first two probes are oke the thirt probe it hits the right site before probing and back on the left side it tries to probe ousite the bed, what could be wrongconfig.g
thanks

@droftarts you where on the right track,one of the endstops was broken i saw movement in it while checking te connection
thank you

@droftarts i will check thanks

homez.g homey.g homex.g homeall.g config.g

config.json