Homing advice
-
the extrude and retract buttons are greyed out on the web interface even after the M302 P1 command
-
How bout if you heat up the hotend to 180?
-
@Phaedrux got it up to 160 and now i can retract and extrude
-
@Phaedrux
M120 M83 G1 E10 F300 M121
Warning: Tool 0 was not driven because its heater temperatures were not high enough or it has a heater fault -
@Phaedrux
at 180 seems to be working. i can see it moving -
Alright, so at least we know the extruder is moving and extruding now.
Next you should go through the extruder calibration to set the correct steps per mm.
https://duet3d.dozuki.com/Guide/Ender+3+Pro+and+Duet+Maestro+Guide+Part+4:+Calibration/40#s165
-
@Phaedrux said in Homing advice:
https://duet3d.dozuki.com/Guide/Ender+3+Pro+and+Duet+Maestro+Guide+Part+4:+Calibration/40#s165
so retract is pushing out filament and extrude is pulling it back......
-
In that case we must change the motor direction once again
M569 P3 S1 ; physical drive 3 goes forwards
Change S1 to S0
-
I was able to print! My temp tower didn’t come out so hot though. What sorta things do I need to look into to fix?
-
-
Now that you have things working somewhat, you should go through the following guides to confirm correct operation and then do some calibration steps.
https://duet3d.dozuki.com/Guide/Ender+3+Pro+and+Duet+Maestro+Guide+Part+3:+Commissioning/39
And
https://duet3d.dozuki.com/Guide/Ender+3+Pro+and+Duet+Maestro+Guide+Part+4:+Calibration/40
-
Went through them both and it helped a bunch but I feel like there is still some room for improvement. Thoughts?
-