Please help.
-
Hi
a friend of mine gave me (as in gift) a duet wifi… so im configuring the thing etc... homed X axis ok then the system halted.... the board is not responsive either with USB or wifi.the diag red led is on... honestly i dont know what to do. Please advice.
-
-
i get 4 lights (3 reds, one green) but no COM on the PC…
-
ok…
i managed to get it connected to COM4.. but cant actuyally connect... so I load the firmware with SAM-BA.thank you jackal for your response...
-
Do you check the endstop wires? Duet wifi uses a different order in the pins. If you connect wrong the board die
-
Do you check the endstop wires? Duet wifi uses a different order in the pins. If you connect wrong the board die
i assume thats what happened.
I have to rewire the connectors and stuff as i put my old mks gen in… but i assume board is fully functional. Such design must have several short protections...
-
Can't have protection in signal line. Try with your mks
-
The Duet WiFi is better protected from user wiring errors than most other controller boards. What is the current problem?
-
The Duet WiFi is better protected from user wiring errors than most other controller boards. What is the current problem?
current problem is that i have to redo the connectors…. i put my old mks board in as i only have one printer.
dumb ass question... will you support the smartcontroller 2004 LCD ?? i hear the 12864 will be supported soon....
-
Support for other LCDs is low on the priority list because there are so many other features that users have requested - see https://www.duet3d.com/forum/thread.php?id=961. They will have to be 3.3V-compatible LCDs, not 5V ones unless you use level-shifters.
Have you considered using your smartphone or tablet to control the Duet WiFi via the web interface, instead of an LCD?
-
Support for other LCDs is low on the priority list because there are so many other features that users have requested - see https://www.duet3d.com/forum/thread.php?id=961. They will have to be 3.3V-compatible LCDs, not 5V ones unless you use level-shifters.
Have you considered using your smartphone or tablet to control the Duet WiFi via the web interface, instead of an LCD?
in fact i am… my current running setup is mks gen with octopi and i control everything remotelly... but i trend to use the kill switch of the smart controller board.