Mosfet issue, E0 heater heats up on startup, E1 blows fuses
-
I just bought a new Duet2 (2.02) from Filastruder about a week ago and setting it up in the new Venturi 3D prototype for ERRF, but ran into quite an issue. I had plugged in some 24 V fans, and started to smell burning on startup.
So I unplugged the printer, then found I blew one of the 7.5 Amp fuses, replaced it, but now the E0 heater just turns on immediately upon startup. After doing some board research, seems a Mosfet is bad, but the other heater doesn't do this.....however
I was hoping to use the other heater, but after trying to set that up, it blows another fuse when turning it on to heat up.
I don't know if I can do anything to get this board working before ERRF (I know, last minute is a bad thing)
Anyone have advice?
(The good news that I'll be 2 booths away from the Duet booth at ERRF)
-
Check the resistance of your hot end heater between the wires where they plug into the Duet. If it's blowing mosfets and fuses, chances are there is a short in the heater or your wiring. Be especially careful if you are trying to use a common VIN+ wire to the heater and fan(s).
-
Does each E0 and E1 heater have a separate mosfet?
-
@technosworld said in Mosfet issue, E0 heater heats up on startup, E1 blows fuses:
Does each E0 and E1 heater have a separate mosfet?
Yes.
