Smart effector on Ramps 1.4?
-
Hello, how do I connect Smart Effector to Ramps 1.4 ? And how do I integrate it into Marlin (or elsewhere)?
-
from the documentation nearly everthing is standard.
https://duet3d.dozuki.com/Wiki/Smart_effector_and_carriage_adapters_for_delta_printerthe only thing that will not work is the programming of the sensitivity
-
but why would you buy a duet smart effector and then not got for a duet board?
-
@speedpete said in Smart effector on Ramps 1.4?:
Hello, how do I connect Smart Effector to Ramps 1.4 ? And how do I integrate it into Marlin (or elsewhere)?
Have you seen https://duet3d.dozuki.com/Wiki/Smart_effector_and_carriage_adapters_for_delta_printer#Section_Compatibility_with_other_electronics_and_firmware ?
-
Oh, there it is
I did not see "select Z probe type 8" ...seems that was my problem… I´ll give it a trial when I´m back home next week Thanks a lot
