@gloomyandy Thanks! I overlooked this. I had this right at one time but then my Config.G and Config.Bak got deleted due to the factory 2 test Macro still being on the SD card. Apparently the config file I used to restore it did not have that correction in it

@jens55
thanks for your help , if i have any more problems ill do my best to read the duet docs

@dc42 I wanted to update you that I managed to do everything and the Multiple Motion System is very powerful, thank you very much everyone!

I'd invest the time and home both tools in X&Y direction while the bed is empty. This way you can be sure, the unused tool is parked where it belongs.
It's debatable if you have to heat up the tools for XY homing/parking, but it's probably touch probe related?
You can rewrite the homing macro to only heat and home Z of the selected tool

@droftarts

As usual... you can not avoid that kind of flaws in a documentation. Anyway, much more easy to identify than the WiFi recent problem. 😉

Cheers, Chriss

Yes, we can close the topic now..... It was my bad! The tool 0 was selected for homez and not deselected anymore. I changed that and it is working as expected now.

Thanks for your support guys!

Cheers, Chriss

@Exerqtor

🤦 Thanks, I remember now. 😉

@gloomyandy Thanks I'll check it out.

@oliof OK JA CHANGE THE CABLES THANK YOU FOR HELP

@dc42 Thanks! It seems that I have overseen one line:

T-1 P0 ; deselect all tools but don't run any tool change macro files

It could be that the wording is a bit misleading. At the the tfree script got executed when I tested.

Cheers, Chriss

@jay_s_uk This is of course also possible. However, as I believe that the weight of the Z-axis with spindle motor is primarily responsible for the lost steps, I rule this out for the time being with a counterweight. Then I will consider whether the motor dimensions are at all practicable.
Here is a photo of the CAD model to give you an idea. Yesterday I made the first chips in Styropr with the real milling machine.
Annotation 2024-02-29 120445.png

@droftarts Good Morning....

I already put the sensors with 4 wired conexion and i have the error again , i don´t know what is happend .......

The pt100 sensors read 2000 ºC when the heater is on every 10 or 15 seconds , is no always the same time , do u think is a interference problem???? , do u think a ferrita core is a possible solution??????

error.jpg

Thanks

@Chriss ok cool, yes on that case that would work

@oliof Thanks, most of the connections are obvious, I can probe out the cable from the print head to the board connector.
There are a couple of connections which I presume cannot be used, one to what looks to be a 'calibration' switch at the rear of the print bed and next to this an 'acc sensor'.

kobra2max_1.jpg

kobra2max_1b.jpg

kobra2max_2.jpg

kobra2max_3.jpg

kobra2max_4.jpg

Thanks @droftarts so i will use manuel Bed Levelling Assistant.

@droftarts There it is! With this change, the stepper finally started working. If I wire to + set then R0 works and if I wire to - R1 is needed.

@haertn3r my suggestion would be use a combination of node-red with the node-red DSF plugin to capture the data into an influxdb time series database. You can then use grafana to display the data.
You can do this fairly easily using this script to install all 3 https://tech.scargill.net/the-script/

@handyandy What type of code are you referring to, G/M/T-codes, comments, or meta G-code like conditionals?