Hello everyone
I am currently trying to connect 100w mitsubishi servos to my 3d printer and I would like to get help
I have 0 idea where to begin, so if someone can point me in the right direction, I would be very thankful.

@mrehorstdmd

I found this too, now I need to figure out how to convert these signals to desired output

@o_lampe I read through the amplifier instruction manual and found that cn1 takes forward and reverse signal, now I need to find some way to convert step/dir to forward and reverse

Hello everyone
I am currently trying to connect 100w mitsubishi servos to my 3d printer and I would like to get help
I have 0 idea where to begin, so if someone can point me in the right direction, I would be very thankful.