Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you have been placed in read-only mode.
Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).
undefined
works perfectly after updating to the new firmware, thx.
Great result with the probe sounds like steps/mm or microstepping are wrong for x.
The fault led will illuminate if the thermocouple is not connected or it is shorted to something else.
I just checked the wiki and although the instruction to use channels 150-153 was included in the Hardware paragraph, it wasn't mentioned in the Firmware Configuration paragraph. I'm sorry if this misled you. I have now corrected it.
