Topics created by ZenekNY

To set the Z height prior to printing, on a delta printer, use something like this:

G1 X0 Y0 Z5 F6000
G30

On a Cartesian printer, replace X0 Y0 by the coordinates of the centre of the bed.

You could try using 8 factor calibration instead of 6 factor, then it will calibrate for bed tilt as well in firmware 1.16 and later. The snag is that it is hard to distinguish between bed tilt and misplaced towers. Using a lot of probe points helps, with some as far from the centre as possible.