@oliof
Thanks for your reply.
I will probably wait until the feature is probably more finished.

@oliof
Thanks for your reply.
I will probably wait until the feature is probably more finished.

Good day everyone
I've seen that RRF supports input shaping.
While the wiki article shows all things I would need to actually connect the sensor to the duet board nothing is really written about how the data is applied.
Is the Implementation similar to klipper, where you can measure the axix separately and you can remove it afterwards?
Another question is how important is pressure advance for it, a lot of videos about klipper and input shaping list pressure advance as a base requirement for it.

@droftarts said in Black Duet 2 Wifi board?:

@x30n It's a clone board, not produced by Duet3D. I doubt it was assembled in the UK!

Ian

That's what I thought.

Didn't the Licence include a clause that forbids the use of the print for the clones and mandates to declare that the product isn't endorsed and supported like in this picture ?

Hello.
I was browsing around, for a used Duet 2 wifi board for a future project.
I found a "used" board that looked weird.
I personally only know the blue duet 2 wifi boards, like my original one I sourced from a reputable german seller.
the board shown was a black duet board v1.2 with the print "Designed and assembled in the UK" with no hint that it isn't an original board.

Am I right with my suspicion that this is a copy with the wrong printing?

Hi
at the moment I use filament specific e-steps in the filament config that were measured through extruding.
If I want to use those features, are those e-steps values usable, or do I need to calibrate without the Bowden setup?
Thanks

My filament sensor shows currently in the Calibration Data a minimum of 0%, avg 130% and max 185%.
Are these valid Data?
I use one of those Designs that measures movement indirectly over a bearing.
My previous calibration had a minimum of 10% and max of 180% but "falsely" triggered multiple times a too little movement error and destroyed the print
( my pause.g had a retraction of 10mm, but because of a new titanium all metal bridge it should retract around 1mm, my fault)
Most example calibrations shows an >0% min, so I am reluctant to put the 0% in my config.g

Ah thanks.

Is there A way to get the current e-step value, to see if the change in the filament config was successfull?

After the first success I didn't had another error.

it first shows 26%, sometimes it directly goes to error and the other times it moves really slowly up and that moment it would go to 100% it shows error.
Tried to upload 8 times and the ninth it uploaded successfully.