Ok thanks
At the moment i print a small temp tower with slow speed (max 40mm/s
automatic settings)) and already are ok for the moment 🙂
I use this settings:
M591 D1 P7 C4 S1 R60:140 L25.926 E15.0 A0
and the console gives me this feedback :
7.4.2020, 18:31:37 M591 D1
Pulse-type filament monitor on endstop input 4, enabled, sensitivity 25.926mm/pulse, allowed movement 60% to 140%, check every 15.0mm, measured sensitivity 25.246mm/pulse, measured minimum 101%, maximum 104% over 757.4mm
later i will trie it with another print and more speed