which sensor (Z-probe) is used ? maybe this is the fault ? I had such a similar problem with the optical sensor of DC on the green gfk print surface. The values were sometimes good and then again bad and partly implausible ! Only after switching to BlTouch did I have reproducible values.
wummelfrosch
@wummelfrosch
Since 2014 with 3D -Print in Contact ! From Marlin, Marlin32bite over Repetier to RRF .
All 3D-Printers are own Build. Second Printer BCN3D Sigma R16 completilly new build and fully optimized and upgraded too R19 in 2020
Best posts made by wummelfrosch
-
RE: bad bed adhesion on one side after rff3 upgrade
Latest posts made by wummelfrosch
-
RE: Mesh Bed compensation "not working enough"
Hy,
what Kind of Z-Probe do you use ? -
RE: possible error in firmware 3.2x
@wilriker
at first... sorry for the delay of my reply, because there are a lot of work in business and at homeI have testing the Firmware 3.2.11 and it seems to work fine for me
Thank you
-
RE: possible error in firmware 3.2x
Great ! I will test it and give you a feeedback again
-
RE: possible error in firmware 3.2x
@wilriker said in possible error in firmware 3.2x:
For version 3.3 a revised fan handling is planned so you can control all fans of all tools in all situations. But no work in this direction has yet been implemented.
ok thank you. I wait for v 3.3 and would be happy if this change is implemented then
-
RE: possible error in firmware 3.2x
@wilriker
oh super... Thank you very much. Just how can I solve you best? as written above I always need both fans, no matter which tool I'm using -
RE: possible error in firmware 3.2x
@wilriker
Hello, nothing changes even after the update to rrf3.2.2. However, I have now noticed the following : if I print with tool 1 it goes ! only with tool2 it is not possible ! I think that could help a lot in the solution. maybe I can fix it with the slicer startcode ? -
RE: Grid Compensation only for a few layers ?
Super, thanks for the hint. I somehow overlooked or misinterpreted this
-
Grid Compensation only for a few layers ?
Hello, is there a possibility to use the grid compensation only for a certain height and then, for example, to let slowly weaken from 3mm or possibly switch off directly ? under my old repetier firmware this was possible. in the docu I found nothing about it. Thank you for the feedback
-
RE: possible error in firmware 3.2x
@wilriker
Hello, thank you for the answer. I've tested it and it's not working. I used the latest RRF and until the update of the Panel Due Firmware it still went. I have to say that I use a Chimera Dual Wakü Hotend and always use both component fans, i.e. right and left at the same time. The firmware was created with the Config tool. In the Config.g, the fans are assigned to both tools ( (F 0:1) ! I need no Hotend fan because i use Wakü. That has always been the case and I haven't changed anything about it.I will try the new Firmware bundle 3.2.2
-
RE: possible error in firmware 3.2x
Hello, is there already a solution for the component fan problem ? Can I do something wrong? at felt one of 10 print it goes and at all other .. Not.
I slice with s3Deven if I manually set the fan on the Panel Due it often does not work !