@jay_s_uk okay, thanks thats easy to make.
Best posts made by Woody78
-
RE: Problem with Z Driver phase B
Latest posts made by Woody78
-
RE: RGBW Neopixel on duet 2 wifi
@droftarts yes i know. i have only the connection problem in my last connector on the hotend...
-
RE: RGBW Neopixel on duet 2 wifi
@droftarts do you know if i can measure the 3.3v every time or only when the board gives a signal?
-
RE: RGBW Neopixel on duet 2 wifi
@droftarts okay, i checked another led strip in spare directly on the board without level shifter. it worked fine. so i have to check my wires to the stealthburner, i hope it is no problem that the wires are over 2m long
-
RE: RGBW Neopixel on duet 2 wifi
@droftarts i´d tried your config with and without level shifter. but nothing happend... i don´t know why...
it is possible to test the led´s on another way... to check? -
RGBW Neopixel on duet 2 wifi
Re: 3.5.0-beta.4 neopixel on duet 2 wifi
hi there, i have installed my stealthburner with 3 LEDs neopixel 5V version.
I have also a logic level shifter between board and leds, but nothing happend.
when i measuring on the pins i have all about 4.95V, i think it is okay...in my config.g i have:
M950 E0 T1 C"connlcd.5" U3
M150 E0 X3 Q3000000
M150 E0 R255 P255the pins on the board i used are:
5V = 1)5V CONN_SD
GND = 2)GND CONN_SD
3.3V = 5) En10 (LCD_DB7) CONN_LCDthe 5V and GND goes direct to LEDs and HighInput of LLC and the 3.3V DataLine goes to LowInput LLC
-
RE: Problem with Z Driver phase B
@jay_s_uk okay, thanks thats easy to make.
-
Problem with Z Driver phase B
Hi there,
i´m using Duet 2 Wifi FW 3.5.3 on my hypercube setup.
now when i home x axis (i drive first z a little bit down) become a warning: Driver 2 warning: phase B may be disconnected
the bed doesn´t move and it´s very load on the z steppers, they are shaking...
few hours ago it´s run normal. then i put the stepper out from the printer, change against other stepper, change back to the old stepper, and everything looks fine. i put the stepper back in the printer, and then works.
after few hours with power off from the printer, i want to test something, first start G28 X and same again.i don´t know what can i do....
-
RE: create new custom button possible
@cosmowave thats great. many thanks
-
create new custom button possible
Hi there, i didn´t find anything to make a own new button in DWC to start for example a macro.
It is generally possible? -
RE: Bad command: Configuration file for Duet WiFi
@chrishamm yes, it is. great. thank you... now everything is fine