Slam
Thanks for the quick response. I have found my problem, my Z axis threaded rods have some bad threads. I will replace them and move on!
Latest posts made by wannathermal
-
RE: Bad Benchy Bottom
-
Bad Benchy Bottom
Thanks for all the help! I have the Duet 2 wifi up and printing! But I have a problem that I can't figure out after searching. The lower half of a Benchy print is bad, the upper half is good considering my machine. I know I have to work on the first layer but this goes half way up the print. I want to print parts for an XY machine so I need to nail this problem down. See the attached picture. I have a couple of ideas but just wanted to run this by the group.
Bob
-
RE: Z probe after updating firmware
Ok, I have my z probe set up and calibrated but for some reason the Z probe reports below 0 when doing a home and bed comp. See attached config files and bed homez.g heightmap.csv config-override.g config.g bed.g map. Again, I have something simple in the configs that is causing this.
-
Z probe after updating firmware
Z probe not working after Updating to
Firmware Name: RepRapFirmware for Duet 2 WiFi/Ethernet
Firmware Electronics:
Duet WiFi 1.02 or later
Firmware Version:
2.02(RTOS) (2018-12-24b1)
WiFi Server Version:
1.23
Web Interface Version:
1.22.6
I know the configuration settings have changed but I can't figure it out.[1_1581529809249_download.zip](Uploading 100%) [0_1581529809228_config.g](Uploading 100%) config.g heightmap.csv homez.g homeall.g -
Blobs Happen
I am having troubles with blobbing. After printing for an hour or so I get a large blob and if I am not right there to clean it then the xy axis will skip. Any ideas?
-
Problem with print
I am having a problem , after printing for 40 minutes it appears the y axis is skipping or something. I can print multiple towers much higher than this without a problem. Any ideas? (of course you guys have ideas! That is why I moved to the DuetWifi from Replicape) -
Thread reversal
I have a logics problem with reversal of xy (long suspected but has not effected prints until now) I just printed a threaded piece, thread along Y axis and the threads are reversed. How do I fix this?
-
RE: Choices!
Well as I am a sailing skipper and have a tight schedule from the middle of June till March it will be a slow process but I will try to update my progress. Going with the XY platform.