@oliof Interesting - for whatever reason I had the Duet3 mini as "fewer channels than Duet2" in my head. Thanks for clearing this up.
Best posts made by vwegert
-
RE: Duet 2 Hangprinter, 5-bar Scara, Polar, Rotary Delta kinematics
-
Update to 3.3 killed Wifi - file (re)location issue?
I have updated my (genuine) Duet 2 Wifi from firmware version 3.2 to 3.3 by uploading the file Duet2and3Firmware-3.3.zip using DWC and confirming the dialog prompt. After the update, I could hear the printer re-starting and going through its homing cycle, but the web interface did not come back. M115 issued through a PanelDue showed the firmware version correctly as 3.3, so the update appeared to have succeeded. M552 showed "WiFi module is being started", even after more than 10 minutes of run time. The Wifi module LED was showing a permanent blue. Cycling the Wifi module state with M552 S-1 followed by M552 S1 did not help.
M587 should show the network list, but it didn't. Instead, I got the message "Failed to retrieve network list: another SPI transfer is pending". I have recently connected an accelerometer to my printer and connected it as described in the documentation, but I have not yet configured the firmware to use it. However, physically disconnecting the accelerometer did not resolve the issue either.
I then tried to reapply the Wifi firmware update using M997 S1, which gave me the error message "Error: M997: file 0:/firmware/DuetWifiServer.bin not found". Examining the SD card folder structure on my PC, I could see all of the firmware files still located in /sys/. Apparently, the file relocations mentioned in the release notes have not been performed automatically - the folder was not even created.
I then moved the firmware over to the new folder manually and reapplied the Wifi firmware update using M997 S1. This finally resolved the problem.
I don't know whether there is some bug in the update procedure or just a fluke - but maybe this will help somebody who ran into the same issue.
-
RE: waste / nozzle priming bucket - material for lip?
@chanders Hmmmm... Makes me want to check whether I could fit the lower half of a soda can into my printer...
-
RE: Delta X/Y - um - "undulations"?
Got it. I recently moved the printer to a new place - from one flat and level surface to another - and I didn't bother to re-level it. That came to bite me now - one of the corners (the front right) was considerably lower than the other ones, introducing a twist into the entire frame that was really hard to spot. Re-leveled the feet, now everything is back to normal (pun intended).