@chrishamm that does appear ( on the first and only try ) to have fixed it - thankyou
Latest posts made by ukwebb
-
RE: Paused message doesnt self clear
-
RE: Paused message doesnt self clear
@phaedrux any thoughts on the issue
- does anyone else have the issue?
-
RE: Paused message doesnt self clear
I'm happy to be proved wrong, but why would it be due to paneldue ? the print does resume and the browser shows that - and the paused message goes from paneldue . Its only on the Duet Web interface that still shows it.
-
RE: Paused message doesnt self clear
@phaedrux updated to 3.4.0
same thing -
Paused message doesnt self clear
Not sure if this is a bug, or a bug that has been fixed but I've noticed that ... if my printer pauses due to the filament sensor, and I then resume the printer via the PanelDue, next time I lview the web interface, the message saying "your print is paused - Extruder 0 reports too little movement" appears, even though in the background you can clearly see the x,y positions moving happily away.
clicking dismiss on the message has zero effect, other than clearing the message - its just concerning when you first view it as you think the printer has paused again.
I'm on stable release 3.3.0 with a Duet3Mini5+ in standalone mode
Any thoughts? -
RE: Dual z Stop and Piezo Bed Level
@palgon no one can give you the exact measurements, other than you, as you have the printer to measure it!.
Home your printer, then move the print head Y position until it's in line with your Y rods. That will give you the Y value.eg something around 165
Then make sure x is at the 0 position and measure the distance from the tip of the nozzle to the approx centre of the z rod.
You'll get something like -30mm. Then move the X across as close as you can to the right side, and again measure the nozzle to rod distance. Remembering to add in the X position. So if the head is at position 330, and the rod is a further 30mm away, then your number is 360mm.So in the examples above the positions would be -30,165 and 360,165
-
RE: total number of layers issue
reprap/sprinter firmware
I am using "Synchronize with object layers " turned off - ie not sync'd
i did wonder if this was the reason, but it looks very odd when it starts showing now on layer 70 of 66 !i've made a simpler layergcode.gcode example gcode file, which has the same effect with 76 layers according to Prusa.
-
RE: Dual z Stop and Piezo Bed Level
@palgon
I have a corexy machine with the same as you describe
ie Duet3 mini5+ ( very similar to duet2 )
two z motors left and right
precision piezo sensoronce you're on RR3 these are the relevant lines in my config
; Z Lead screws
M671 X-100:400 Y160:160 S20 ; leadscrews at left (-100,160) and right (400,160); Endstops
M574 Z1 S2 ; configure Z-probe endstop for low end on Z; Z-Probe
M558 P8 R0.3 F150 T4200 C"!io3.in" H3 ; PP sensor in digital mode connected it io3.in
G31 Z0.05 ; set Z probe trigger value, offset and trigger heightM557 X20:280 Y20:280 S60 ; define mesh grid