@OwenD Thank you Owen. I figured it out. I cut open the RJ11 cable, crimped the 2 middle wires (of 4) into a molex connector, and made sure I was matching L to L and H to H.
Best posts made by tylersuard
-
RE: How do I install the 1HCL on the Duet3 Mini 5+?posted in Duet Hardware and wiring
-
RE: Web UI not accessible if I leave printer on Pause for too longposted in General Discussion
I was able to solve the problem by connecting to my board via USB and turning the board's wifi off with M552 S-1 and then on again with M552 S1
-
RE: Retraction settings changed mid-print?posted in Using Duet Controllers
The answer: I had created a retraction tower earlier. The "alter Gcode" plugin was still active even though it was not visible, and was increasing my retraction distance every 20 layers.