Topics created by TimTom

@phaedrux
Ahh ok, so you already adjusted the partition scheme, great to hear 🙂

According to serial my board was 2021-06.
Nevertheless I'd add a note to Setup/install guide, I'd written something but can't find my docu credentials at the moment.

@zapta

Thanks for your input, in this thread I figured out, that my main problem was, that the fans are "not" PWM compatible.
That means fiddeling around with the frequency.

Sooner or later, I'll probably switch over to 12V fans. There choice in 24V is pretty limited. Thanks to Duet Hardware, it's pretty easy to run the board with 24V and the fans with 12V (which then can handle PWM).

Then the standard config with M106 should be sufficient.

@timtom, that's normal. We all struggle with similar problems.

😉

@timtom you will need to fill in the form anyway so that we can contact Filafarm and authorise them to replace your board. Yes Brexit is a horrible mess and makes things difficult, so we will arrange for Filafarm to provide the replacement.