Thanks to all of you my carthesian is printing now. Currently tuning acceleration and jerk. I also need to center the pritnbed still as you can see.

Making good progress though. If this goes will I might upgrade my delta to a Duet too.

Last update on this topic.
It is dialed in now and it is fantastic.
I wont use any other board on any printer from now on.

It's a simple cartesian but wow does it print well.

Thanks to all of you my carthesian is printing now. Currently tuning acceleration and jerk. I also need to center the pritnbed still as you can see.

Making good progress though. If this goes will I might upgrade my delta to a Duet too.

Apparently the thermistor was screwed in too hard. The set screw put too much pressure on the wiring. It works now.
Pid tuning the hotend now. Weeee!
Sure had some hurdles on the way on this one but the DuetWifi really grows on me. I love the webinterface and the fact I can modify the config via interface - that's brilliant.

@veti
Thanks. Yep the Thermistor is dead out of the box. Plugged in a different one and it reads room temp.
I got some teething issues on this one.
Thanks.

Thermistor always shows 2000 C.

Closing in to get it running. Axis Home. Endstops work. Fans work. Bed heats.
Only the hotend keeps bugging me.

It's a 3d Freunde e3d Full Metal Hotend.

I get the error: Heater 1 fault (T0) - 2000°C

I tried the original E3D thermistor values. I tried the values that work for the 3D Freunde Hotend in Marlin (B 3950) but all I get is a heater fault.

The thermistor and heater are wired to E0.

Heatbed works fine. Pid tuning it right now.

Thank you. I will try that.
I can't use thos commands. Insufficient axis homed. Only works after homing I guess? I managed to fix it now. All axis homing against endstop fine.

Fixed the fan. I got an issue with z homing. It tries to home on top but I got a min Z endstop.
Considering it lifts z correctly before homing X and Y I think the Z axis direction should be correct.

I've added the z homing file.

I am sorry for all the questions.0_1545818773565_homez.g

@wilriker
Changed steps. Thank you.

Edit: Fantastic. Making progress. All endstops working. Axis are homing.
Now On to the hotend and the no power on fans issue. I shall read up on it first though. I went at this a bit to unprepared.

Thanky ou very much btw. I am starting to get the hang of it.

@wilriker

Thanks a lo. I will look into it. The Endstops were the wrong way round. Fault number one solved as well.
Sorry for my stupid questions. I am new to this. I thought the basic config of RFF config tool will get me somewhere. I found no basic values to start with for the anet.

X stall detection is because one switch died. I just fixed it though - back to endstop.