Best posts made by The Chairman

Sry, this was too easy and I gave up before I needed to. I found this code and am running it now...

m303 h0 s100

@fcwilt Thanks for the input. I tried copying code on my phone yesterday and the forum gave me an error. A friend suggested that I run m119 in the console and it showed the z stop as being off. I looked over the wiring this morning to discover that the z probe cable was plugged into the wrong spot on the Duet. Problem solved.

I am trying to suss out my Crealty CR Touch, but I'll start another thread on it when I'm ready for input.

@jrcl Again, thanks. It has finished the auto-tune and gave me this message:

Auto tuning heater 0 completed after 3 idle and 5 tuning cycles in 998 seconds. This heater needs the following M307 command:
M307 H0 R0.532 K0.167:0.000 D13.56 E1.35 S1.00 B0
Edit the M307 H0 command in config.g to match this. Omit the V parameter if the heater is not powered from VIN.

I didn't see a "V" parameter in that line of code and am not sure what VIN means in this context, in any event. I easily found the line of code in my config.g and have replaced it.

Thanks to everyone here the printer is printing... I am waiting on terminals to finish the CR Touch install and I'm pretty much ready to play with it.

[center]

[/center]