Re: Error: Attempting to extrude with no tool selected

I was able to find the solution to my problem the the no tool selected error.
I have multiple printer like any one else here and I use Cura to slice my g-codes and that is where my problem was.

The first thing I fixed was I changed the g-code flavor in 3d printer settings to RepRap I don't know why but it defaulted Marlin.

2nd I unchecked marked apply Extruder offsets to gcode.

3rd and final attempt that I believe fixed my problem. I have printers with multiple extruders but not on this one its a single extruder.
I went into extensions next to settings in Cura and post processing > modify G-Code.
Here I found I left a scrip for color mix on so I removed the script and reprinted with success.
I recommend Clearing all scripts and that's how I fixed my little issue with no tool selected.

Re: Error: Attempting to extrude with no tool selected

I was able to find the solution to my problem the the no tool selected error.
I have multiple printer like any one else here and I use Cura to slice my g-codes and that is where my problem was.

The first thing I fixed was I changed the g-code flavor in 3d printer settings to RepRap I don't know why but it defaulted Marlin.

2nd I unchecked marked apply Extruder offsets to gcode.

3rd and final attempt that I believe fixed my problem. I have printers with multiple extruders but not on this one its a single extruder.
I went into extensions next to settings in Cura and post processing > modify G-Code.
Here I found I left a scrip for color mix on so I removed the script and reprinted with success.
I recommend Clearing all scripts and that's how I fixed my little issue with no tool selected.

@misterj said in z-probe reading at 1000:

M558 P5 l0 R0.7 F400 X0 Y0 Z0 ; (digital mode, NO/NC, delay, speed, not used as axis endstop

I have a SN04 probe and it was doing the same until I changed invert command to (I1) on the M558 gcode

Anet A8 comes with 12v fans and 12 psu configuring this is not easy since board only supply's 5v I haven't found a wiring diagram for this in the forums.