I have 2 printers 1 X5S, and 1 X5SA both are setup the same only problem when i slice a stl file in cura. it prints perfect in the X5S, but does not scale correctly on X5SA. keeps giving me a message.
M32 "0:/gcodes/CFFFP_CR-10_HD-modular-mount-V6_mount-cover__40mm-fan_v1.gcode"
File 0:/gcodes/CFFFP_CR-10_HD-modular-mount-V6_mount-cover__40mm-fan_v1.gcode selected for printing
T0:23.1 /0.0 B:23.6 /70.0

@bearer yes. maybe the board had to warm up. got me stumped. i have come across weirder things than that unfortunately.

@droftarts finally got it to work. took sd card from working duet printer. ran a M21&M39, went to working.

@tdybare69 its new board. but i have had it for a while in box, stored safely. got it from matter hackers.

@tdybare69 i think your right. something has to be wrong with board.everything i try it still says none.

@bearer i think thts it . be right back gonna make sure there is no partitions. it says files none.

@bearer i went to github got the files you said,extracted it,and tried again. still says same thing. did M21 it says SDHC card mounted in slot 0, capacity 31.9GB<LF>ok<LF>
M39 says SDcard in slot 0: capacity 31.9GB, speed20.00MBytes/sec,cluster size 167kb<LF>ok<LF>

i replaced it with a working sdcard from other printer still no go. seems like board is not mounting sd card. is there a code i can use in yat to tell it to mount the card?

after enabling the wifi module, and entering the router setting when i go to the ip address it gives me i get a reject message

Your Duet rejected the HTTP request: page not found
Check that the SD card is mounted and has the correct files in its /www folder
please help.
could it be that i have a second printer running at the same time.

@bearer thank you