@stefanme said in Stepper motors are super noisy... wrong config?:

@dc42 said in Stepper motors are super noisy... wrong config?:

M569 P0

I use this motors: ACT NEMA 17 1.3A

M569 P0
Drive 0 runs forwards, active low enable, step timing 0.0:0.0:0.0:0.0 us, mode spreadCycle, ccr 0x101b4
M569 P1
Drive 1 runs forwards, active low enable, step timing 0.0:0.0:0.0:0.0 us, mode spreadCycle, ccr 0x101b4
M569 P2
Drive 2 runs forwards, active low enable, step timing 0.0:0.0:0.0:0.0 us, mode spreadCycle, ccr 0x101b4
M350
Microstepping - X:16(on), Y:16(on), Z:16(on), E:16(on):16(on)

Thanks for checking. Are the motors noisy when idle, or only when moving?

Those motors have higher inductance than most but should be OK, especially as you are using 24V power.